ters akınt

listen to the pronunciation of ters akınt
Турецкий язык - Английский Язык
backset
The term backset is used to explain the distance from the edge of the door to the center of the hole drilled for your knob, lever or deadbolt
The distance from the edge of the door to the center of the hole drilled for your entry set knob, lever or deadbolt
The horizontal distance from the face of the lock to the centre line of the cylinder, key hole or knob hub
A term used in referring to the horizontal distance from the face of the lock to the centerline of the cylinder, keyhole or knob hub On locks with beveled fronts, this distance is measured from the center of the lock edge On locks with rabbeted fronts it is measured from the lower step of the center of the lock face
Distance from lock trim face to centerline of cylinder and/or lock hub (Always measured from the center of the lock face )
Whatever is thrown back in its course, as water
Distance from vertical centerline of leading edge of lock stile of door to centerline of lock cylinder, measure parallel with door face
{i} current in the opposite direction (especially of water); reversal or backtracking
The horizontal distance from the edge of the door to the central line of the cylinder key hole
To plow again, in the fall; said of prairie land broken up in the spring
A check; a relapse; a discouragement; a setback
Measurement from edge of door to center of doorknob (and spindle hub where spindle passes through latch)
A longbow design where unbraced limbs angle backward, away from the shooter
The distance from the edge of the door to the centerline of the cylinder at the centerline of the door thickness
See: Hinge Backset
(US term) In North American whiskeys, the alcohol-free liquid left at the bottom of the still and is added to both the Mash Tun and fermenter (or Washback) to ward off bacterial contamination Also known as thin stillage
The horizontal distance from the edge of a door to the center of a lockset
The distance from the edge of the door to the center of the lockset bore Backset distances can be 5", 2-3/4" or 2-3/8" (the most common)
ters akınt
Избранное