cmr

listen to the pronunciation of cmr
الإنجليزية - الإنجليزية
cargo management re-engineering
Riser cable is listed for use in a vertical shaft and has fire resistant characteristics capable of preventing the carrying of fire from floor to floor
Cornwall Minerals Railway
Convention on the Contract for the Interational Carriage of Goods by Road, Geneva, 1956 (amended 1978)
Chloroform-Methanol Residue
(COMMON MODE REJECTION) - THE ABILITY OF A DIGITAL INSTRUMENT TO ELIMINATE NOISE BETWEEN THE INPUT SIGNAL AND GROUND EXPRESSED IN db 120 db = 1,000,000: 1 REJECTION RATIO
is the Cumulated Material Requirement, a quantitative measure of the total amount of raw materials needed to deliver a product or a service In GEMIS, the CMR is the material complement to the CER
call management record Contains the count of bytes sent, packets sent, jitter, latency, dropped packets, etc Also called diagnostic records
Conditional Medical Release This program allows terminally ill or permanently incapacitated inmates to be released from prison prior to the completion of their sentence Inmates released under this program remain under the supervision of a Florida Department of Corrections probation officer and review of the Florida Parole Commission
abbr Cellular Mobile Radio
– Compact Measurement Record, type 2 A correction message which is broadcast by the base receiver and used in RTK surveys to calculate an accurate vector from the base to the rover
Convention on the Contract for the International Carriage of Goods by Road
Common-Mode Rejection states the ability of a digital voltmeter (DVM) to reject noise which appears between the input terminals (high and low) and ground CMR is needed only when the DVM ground is different from the ground of the source being measured When a DVM is operated from line source of power or when both high and low inputs are raised above ground, coupling (impedance) paths exist which introduce noise Highest CMR exists in a battery operated digital multimeter (DMM) Particular care should be taken when data outputs are used For above ground measurements, data outputs and inputs must be isolated through the use of transformers or opto-isolation
Riser Rated Communications Cable
Crisis Manpower Requirement
Cell Mis-insertion Rate In an ATM network, the total number of misinserted cells observed during a specified time interval divided by the time interval duration
Call Modification Request in SS7
The ability of a panel meter to eliminate the effect of AC or DC noise between signal and ground Normally expressed in dB at dc to 60 Hz One type of CMR is specified between SIG LO and PWR GND In differential meters, a second type of CMR is specified between SIG LO and ANA GND (METER GND)
Cell Misinsertion Rate: The ratio of cells received at an endpoint that were not originally transmitted by the source end in relation to the total number of cells properly transmitted